Lancer L4-2.4L SOHC (2005)
STEP 9. Check power window main switch connector E-05 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Is power window main switch connector E-05 in good condition?
YES: Go to Step 10.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the power windows work normally.
STEP 10. Check the ground circuit to the power window main switch. Measure the resistance at power window main switch connector E-05.
1. Disconnect power window main switch connector E-05 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 8 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 12.
NO: Go to Step 11.