Montero V6-3.8L SOHC (2005)
STEP 6. Check the harness wires between D-07 (terminal 26) and battery.
NOTE: Also check intermediate connector D-28, check the wires. If intermediate connector D-28 are damaged, repair or replace them. Refer to Harness
Connector Inspection.
Q: Is the harness wires between D-07 (terminal 26) and battery in good condition?
YES: There is no action to be taken.
NO: Repair them. The RV meter should work normally.
STEP 7. Check the RV meter power supply circuit [ignition switch (ACC)] at the RV meter connector D-07 by backprobing.
1. Do not disconnect the RV meter connector D-07.
2. Turn the ignition switch to "ACC" position.
3. Measure the voltage between terminal 25 and ground by backprobing.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 10.
NO: Go to Step 8.
STEP 8. Check RV meter connector D-07 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is RV meter connector D-07 in good condition?
