Montero V6-3.8L SOHC (2005)
2. Measure the resistance value between terminal 5 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 7.
NO: Go to Step 6.
STEP 6. Check the wiring harness between windshield wiper motor connector B-12 (terminal 5) and ground.
Q: Is the wiring harness between windshield wiper motor connector B-12 (terminal 5) and ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector may have loose, corroded or damaged terminals, or terminals pushed back in the connector.
Repair the wiring harness as necessary. Verify that the windshield wiper works normally.
STEP 7. Check front-ECU connector A-08X for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is front-ECU connector A-08X in good condition?
YES: Go to Step 8.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the windshield wiper works normally.
STEP 8. Check the ignition switch (ACC) circuit to the front-ECU. Test at front-ECU connector A-08X.
