Montero V6-3.8L SOHC (2005)
STEP 12. Check position light (LH) connector A-18 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is position light (LH) connector A-18 in good condition?
YES: Go to Step 13.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the position light (LH) illuminates normally.
Part 2 of 4
STEP 13. Check the ground circuit to the position light (LH). Test at position light (LH) connector A-18.
1. Disconnect position light (LH) connector A-18 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 1 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 15.
NO: Go to Step 14.
