Montero V6-3.8L SOHC (2005)
STEP 21. Check the harness wiring from ETACS-ECU connector D-222 (terminal 17) to rear passenger's door lock actuator (RH) connector
H-21 (terminal 2).
NOTE: Also check junction block connector D-209 and intermediate connector D-111 and F-23 for loose, corroded, or damaged terminals, or terminals
pushed back in the connector. If junction block connector D-209 or intermediate connector D-111 or F-23 are damaged, repair or replace the damaged
component(s) as described in Harness Connector Inspection.
Q: Is the harness wiring from ETACS-ECU connector D-222 (terminal 17) to rear passenger's door lock actuator (RH) connector H-21 (terminal 2) in
good condition?
YES: Replace the ETACS-ECU. Verify that all the doors can be locked and unlocked normally.
NO: The harness wiring may be damaged or the connectors may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the harness wiring as necessary. After repairs have been made, verify that all the doors can now be locked and unlocked normally.
