Montero V6-3.8L SOHC (2005)
Operate scan tool MB991958 according to the procedure below to display "REAR WIPER."
1. Select "SWS."
2. Select "SYSTEM SELECT."
3. Select "SWS MONITOR."
4. Select "FUNCTION DIAG."
5. Select "REAR WIPER."
Check that normal conditions are displayed on the items described in the given table.
Q: Are normal conditions displayed for "REAR WIPER SW" and "IG SW (ACC)"?
Normal conditions are displayed for all the items : Go to Step 3.
Normal condition is not displayed "REAR WIPER SW" : Refer to Inspection Procedure O-7 "ETACS-ECU does not receive any signal from the
rear wiper switch."
Normal condition is not displayed for "IG SW (ACC)" : Refer to Inspection Procedure O-1 "ETACS-ECU does not receive any signal from the
ignition switch (ACC)."
STEP 3. Check the rear wiper motor connector I-07 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is rear wiper motor connector I-07 in good condition?
