Montero V6-3.8L SOHC (2005)
YES: Go to Step 4.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the rear wiper works normally.
STEP 4. Check the battery power supply circuit to the rear wiper motor. Test at rear wiper motor connector I-07.
1. Disconnect rear wiper motor connector I-07 and measure the voltage available at the harness side of the connector.
2. Turn the rear wiper switch to the "ON" position.
3. Measure the voltage between terminal 2 and ground.
-
The voltage should be approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 8.
NO: Go to Step 5.
STEP 5. Check the ETACS-ECU connector D-222 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is and ETACS-ECU connector D-222 in good condition?
YES: Go to Step 6.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the rear wiper works normally.