Montero V6-3.8L SOHC (2005)
STEP 36. Check the wiring harness between rear personal light (RH) connector F-04 (terminal 3) and ETACS-ECU connector D-222 (terminal
18).
NOTE: Also check intermediate connector D-26 and junction block connector D-207 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector D-207 or intermediate connector D-26 is damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between rear personal light (RH) connector F-04 (terminal 3) and ETACS-ECU connector D-222 (terminal 18) in good
condition?
YES: Replace the ETACS-ECU. Verify that the rear personal light (RH) illuminates normally.
NO: Repair the wiring harness. Verify that the rear personal light (RH) illuminates normally.
STEP 37. Check the rear personal light (RH) bulb.
Q: Is the rear personal light (RH) bulb in good condition?
YES: Go to Step 38.
NO: Replace the bulb. Verify that the rear personal light (RH) illuminates normally.
STEP 38. Check rear personal light (RH) connector F-04 for damage.
Q: Is rear personal light (RH) connector F-04 in good condition?
YES: Go to Step 39.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Verify that the rear personal light (RH) illuminates normally.
STEP 39. Check the fusible link (1) line of the power supply circuit to the rear personal light (RH). Test at rear personal light (RH) connector
F-04.
