mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2837 > < Initial Inspection and Diagnostic Overview|Page 2835
Page 378
background image

1. Disconnect rear personal light (RH) connector F-04 and measure the voltage available at the wiring harness side of the connector.

2. Measure the voltage between terminal 1 and ground.

-

The measured value should be approximately 12 volts (battery positive voltage).

Q: Does the measured voltage correspond with this range?

YES: Replace the rear personal light (RH). Verify that the rear personal light (RH) illuminates normally.

NO: Go to Step 40.

Initial Inspection and Diagnostic Overview|Page 2837 > < Initial Inspection and Diagnostic Overview|Page 2835