Montero V6-3.8L SOHC (2005)
STEP 6. Check the wiring harness between transmission range switch connector C-04 (terminal 8) and ETACS-ECU connector D-224 (terminal
35).
NOTE: Also check joint connector D-116, intermediate connectors E-111 and E-114 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If joint connector D-116, intermediate connector E-111 or E-114 is damaged, Repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between transmission range switch connector C-04 (terminal 8) and ETACS-ECU connector D-224 (terminal 35) in good
condition?
YES: Replace the ETACS-ECU. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the transmission range
switch.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the
transmission range switch.
