Montero V6-3.8L SOHC (2005)
STEP 4. Check the wiring harness between transmission range switch connector C-04 (terminal 7) and the ignition switch (IG1).
NOTE: Also check junction block connectors D-208, D-212 and intermediate connector E-11 for loose, corroded, or damaged terminals, or terminals
pushed back in the connector. If junction block connector D-208, D-212 or intermediate connector E-11 is damaged, Repair or replace the damaged
component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between transmission range switch connector C-04 (terminal 7) and the ignition switch (IG1) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the
transmission range switch.
STEP 5. Check ETACS-ECU connector D-224 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Are ETACS-ECU connector D-224 in good condition?
YES: Go to Step 6.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the rear wiper operates normally, it indicates that a
correct "R" position signal is sent from the transmission range switch.