Montero Endeavor 4WD V6-3.5L SOHC (2000)
1. Insert a screwdriver [1.4 mm (0.06 in.) width] as shown in the figure, disengage front holder, and remove it.
2. Insert the harness terminal to be repaired deep into the connector from harness side and hold it there.
3. Insert the tip of the screwdriver [1.4 mm (.06 in.) width] into the connector as shown in the figure, raise the housing lance slightly with it, and pull
out the harness.
CAUTION: Tool No. 753787-1 supplied by AMP can be used instead of screwdriver.
4. Insert a needle through the hole provided on the terminal and raise the contact point of the male terminal.
ROUND WATERPROOF CONNECTOR
