Montero Sport V6-3.5L SOHC (2004)
STEP 3. Check the harness wires between daytime running light-ECU connector A-96 (terminal No.1) and fusible link No. 11.
Q: Are the harness wires between daytime running light-ECU connector A-96 (terminal No.1) and fusible link No. 11 in good condition?
YES: Go to step 4.
NO: Repair or replace the damaged components. Refer to Harness Connector Inspection.
STEP 4. Check the daytime running light-ECU power supply circuit (IG2) at the daytime running light-ECU connector A-96.
1. Disconnect the daytime running light-ECU connector A-96.
2. Turn the ignition switch "ON" position.
3. Measure the resistance between terminal 2 and ground.
Q: Is battery positive voltage (approximately 12 volts) present?
YES: Go to Step 7.
NO: Go to Step 5.
