mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Ignition Switch|Page 3999 > < Ignition Switch|Page 3997
Page 17
background image

1. Disconnect daytime running light-ECU connector A-96.

2. Measure the voltage between terminal 1 and ground.

Q: Is the voltage 12 volts (battery positive voltage) between terminal 1 and ground?

YES: Go to Step 3.

NO: Go to Step 2.

STEP 2. Check daytime running light-ECU connector A-96 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.

Q: Are the connectors and terminals in good condition?

YES: Go to Step 3.

NO: Repair or replace the damaged components. Refer to Harness Connector Inspection.

Ignition Switch|Page 3999 > < Ignition Switch|Page 3997