Montero Sport LTD 2WD V6-3.5L SOHC (2000)
Throttle Body: Service and Repair
Throttle Body (Throttle Valve Area) Cleaning
1. Start the engine and warm it up until the coolant is heated to 80 °C (176 °F) or higher. Stop the engine.
2. Remove the air intake hose from the throttle body.
CAUTION: Do not allow cleaning solvent to enter the bypass passage.
3. Plug the bypass passage inlet (arrow) of the throttle body.
4. Spray cleaning solvent into the valve through the throttle body intake port and leave it for approximately five minutes.
5. Start the engine, race it several times and then idle it for about 1 minute. It the idling speed becomes unstable (or if the engine stalls) due to the
bypass passage being plugged, slightly open the throttle valve to keep the engine running.
6. If the throttle valve deposits are not removed, repeat steps 4 and 5.
7
Unplug the bypass passage inlet.
8. Attach the air intake hose.
9. Use the scan tool to erase any diagnostic trouble code.
10. Adjust the basic idle speed.
NOTE: If the engine hunts while idling after adjustment of the basic idle speed, disconnect the (-) cable from the battery for 10 seconds or more,
and then reconnect it and run the engine at idle for about 10 minutes after the engine is warmed up.
