mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 6645 > < Initial Inspection and Diagnostic Overview|Page 6643
Page 5
background image

YES: Go to Step 7.

NO: Repair or replace it. Refer to Harness Connector Inspection. The dome light and cargo space light should illuminate.

STEP 7. Check the harness wires between dome light connector E-20<vehicles with sunroof> or E-21 <vehicles without sunroof>, cargo space
light connector E-16 and fusible link number 6.

NOTE:  After checking junction block connector D-01 and D-07, IOD or storage connector A-54X, check the wires. If junction block connector D-01
and D-07, IOD or storage connector A-54X are damaged, repair or replace them. Refer to Harness Connector Inspection.

Q: Are the harness wires between dome light connector E20<vehicles with sunroof> or E-21 <vehicles without sunroof>, cargo space light
connector E-16 and fusible link number 6 in good condition?

YES: Go to Step 8.

NO: Repair them. The dome light and cargo space light should illuminate.

STEP 8. Recheck for malfunction.

Q: Is a malfunction eliminated?

YES: This diagnosis is complete. (If no malfunctions are not found in all steps, an intermittent malfunction is suspected. Refer to How to Use
Troubleshooting/Inspection Service Point.)

NO: Go to step 1.

Inspection Procedure 2

Dome light and cargo space light dimming function does not work normally.

TECHNICAL DESCRIPTION (COMMENT) The ETACS-ECU dims the dome light and cargo space light according to the input signals from the

Initial Inspection and Diagnostic Overview|Page 6645 > < Initial Inspection and Diagnostic Overview|Page 6643