Montero SR 4WD V6-3.5L DOHC (1995)
Acceleration/Deceleration Sensor: Testing and Inspection
G-Sensor Output Voltage Check (With Scan Tool)
G-SENSOR OUTPUT VOLTAGE CHECK
1. Unload the vehicle and move it to a horizontal surface.
2. Connect the scan tool to the data link connector.
Caution: Turn the ignition switch off before connecting or disconnecting the scan tool.
3. Start the engine.
Caution: At this time, check to be sure that the ABS warning light illuminates for a brief period before turning off. If it does not turn off, refer to
ABS Warning Light Inspection. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Component
Tests and General Diagnostics/ABS Warning Light Inspection
4. Check that the G sensor output voltage is within the standard value range.
Standard value: 2.5 ± 0.12 V
5. If the G sensor output voltage is not within the standard value range, check the installation condition of the G sensor. If there is a loose bolt,
deformation of the G sensor bracket, etc., carry out a repair. If the problem is not repairable, replace the G sensor.
