Montero SR 4WD V6-3.5L SOHC (1997)
Cruise Control Switch: Component Tests and General Diagnostics
Power Switch Check
1. Turn the ignition switch to ON.
2. Check that the indicator light within the switch illuminates when the main switch is turned to ON.
Operations Check
Cruise Control Setting Check
1. Switch ON the main switch.
2. Drive at the desired speed above approximately 40 km/h (25 mph).
3. Turn the control switch to the SET position.
4. Check that when the switch is released the speed is the desired constant speed.
NOTE: If the vehicle speed decreases to approximately 15 km/h (9 mph) below the set speed, because of climbing a hill for example, the cruise
control will be canceled.
Speed Increase Setting Check
1. Set to the desired speed.
2. Turn the control switch to RESUME.
3. Check that acceleration continues while the switch is pressed, and that when it is released the constant speed at the time when it was released
becomes the driving speed.
NOTE: Even if, during acceleration, the vehicle speed reaches or exceeds the high limit [approximately 200 km/h (124 mph)], acceleration will
continue, however, when the switch is released, the set speed ("memorized speed") will become the high limit of the vehicle speed.
Speed Reduction Setting Check
1. Set to the desired speed.
