Montero XLS 4WD V6-3.5L SOHC (2001)
Use a drill [4.5 mm (0.18 inch)] to make a hole in the rivet to break it, and then remove the rivet.
ASSEMBLY SERVICE POINT
>>A<< REAR MUDGUARD REINFORCEMENT, REAR BUMPER SIDE SILL RETAINER AND REAR BUMPER CORNER BRACKET
INSTALLATION
Use the rivet tool shown in the illustration to connect the rivet by the following procedure.
1. Insert the rivet into the base material (rear bumper side face, rear mudguard reinforcement, rear bumper side reinforcement or rear bumper corner
bracket).
2. Place the recommended tool over section A of the rivet.
3. While pushing the flange surface of the rivet with the recommended tool, press the handle of the tool.
4. The thin part of section A of the rivet will break and the rivet will then be attached.
