Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 4. Check the sunroof motor assembly power supply circuit [fusible link (2)] at the sunroof motor assembly connector F-02 by
backprobing.
1. Do not disconnect the sunroof motor assembly connector F-02.
2. Measure the voltage between terminal 3 and ground by backprobing.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 7.
NO: Go to Step 5.
STEP 5. Check sun roof motor assembly connector F-02 for damage.
Q: Is sunroof motor assembly connector F-02 in good condition?
YES: Go to Step 6.
NO: Repair or replace it. Refer to Harness Connector Inspection. The sunroof should work normally.
STEP 6. Check the harness wires between sunroof motor assembly connector F-02 and fusible link (2).
