mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2086 > < Initial Inspection and Diagnostic Overview|Page 2084
Page 56
background image

STEP 14. Check the sunroof switch.

Q: Does the check above meet the table?

YES: Go to Step 15.
NO: Replace the sunroof switch. The sunroof should work normally.

STEP 15. Check the sunroof switch ground circuit at the sunroof switch connector F-01.

1. Disconnect the sunroof switch connector F-01 and measure at the harness side.

2. Measure the resistance between terminal 4 and ground.

Q: Is the resistance less than 2 ohm?

YES: Go to Step 18.
NO: Go to Step 16.

STEP 16. Check the sunroof switch connector F-01 for damage.

Q: Is sunroof switch connector F-01 in good condition?

Initial Inspection and Diagnostic Overview|Page 2086 > < Initial Inspection and Diagnostic Overview|Page 2084