mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2184 > < Initial Inspection and Diagnostic Overview|Page 2182
Page 154
background image

STEP 3. Check the theft-alarm horn. Connect the battery as shown and check that the theft-alarm horn sounds.

Q: Is the theft-alarm horn in good condition?

YES: Go to Step 4.
NO: Replace it. The horn should sound when the theft-alarm system is triggered.

STEP 4. Check the theft-alarm horn relay.

Q: Is the theft-alarm horn relay in good condition?

YES: Go to Step 5.
NO: Replace it. The horn should sound when the theft-alarm system is triggered.

STEP 5. Check the theft-alarm horn relay power supply circuit at the theft-alarm horn relay connector A-11X.

1. Disconnect the theft-alarm horn relay connector A-11X and measure at the relay box side.

2. Measure the voltages between terminals 3, 5 and ground.

Q: Are the voltages approximately 12 volts (battery positive voltage)?

Initial Inspection and Diagnostic Overview|Page 2184 > < Initial Inspection and Diagnostic Overview|Page 2182