Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 3. Check fog light switch connector D-127 for damage.
Q: Is fog light switch connector D-127 in good condition?
YES: Go to Step 4.
NO: Repair or replace it. Refer to Harness Connector Inspection. The fog light switch input signal should be able to be checked and the fog light
should work normally.
STEP 4. Check the harness wires between log light switch connector D-127 and ground.
NOTE: After checking joint connector D-30, check the wires. If joint connector D-30 is damaged, repair or replace it. Refer to Harness Connector
Inspection.
Q: Are the harness wires between fog light switch connector D-127 and ground in good condition?
YES: There is no action to be taken.
NO: Repair them. The fog light switch input signal should be able to be checked and the fog lights should work normally.
STEP 5. Check fog light switch connector D-127 and ETACS-ECU connector D-224 for damage.
