Montero XLS 4WD V6-3.5L SOHC (2001)
and the rear wiper should work normally.
STEP 4. Check the harness wires between park/neutral position switch connector C-04 and ignition switch (IG1).
NOTE: After checking intermediate connector E-11, joint connector D-01 and junction block connectors D-212 and D-208, check the wires. If
intermediate connector E-11, joint connector D-01 and junction block connectors D-12 and D-208 are damaged, repair or replace them. Refer to Harness
Connector Inspection.
Q: Are the harness wires between park/neutral position switch connector C-04 and ignition switch (IG1) in good condition?
YES: There is no action to be taken.
NO: Repair them. The park/neutral position switch "R" position signal should be able to be checked and the rear wiper should work normally.
