Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 7. Check the harness wires between rear wiper motor connector I-07 and ETACS-ECU connector D-222.
NOTE: After checking intermediate connectors G-10 and D-111 and junction block connector D-217, check the wires. If intermediate connectors G-10
and D-111 and junction block connector D-217 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between rear wiper motor connector I-07 and ETACS-ECU connector D-222 in good condition?
YES: Replace the ETACS-ECU. The rear wiper motor auto-stop signal should be able to be checked and the rear wiper should stop at the
predetermined park position.
NO: Repair them. The rear wiper motor auto-stop signal should be able to be checked and the rear wiper should stop at the predetermined park
position.
Inspection Procedure Q-8
The driver's seat belt switch is not sent to the ETACS-ECU
