Montero XLS 4WD V6-3.5L SOHC (2001)
2. Measure the resistance between terminal 6 and ground.
Q: Is the resistance less than 2 ohm?
YES: Go to Step 24.
NO: Go to Step 22.
STEP 22. Check rear door lock actuator switch (RH) connector H-21 for damage.
Q: Is rear door lock actuator switch (RH) connector H-21 in good condition?
YES: Go to Step 23.
NO: Repair or replace it. Refer to Harness Connector Inspection. The input signal from the rear door lock actuator switch (RH) should be able to be
checked and the functions, which are described in the "Technical Description (comment)," should work normally.
STEP 23. Check the harness wires between rear door lock actuator switch (RH) connector H-21 and ground.
NOTE: After checking intermediate connector F-23, check the wires. If intermediate connector F-23 is damaged, repair or replace it. Refer to Harness
