Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking intermediate connectors G-11 and D-111, check the wires. If intermediate connectors G-11 and D-111 are damaged, repair or
replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between back door lock actuator switch connector I-05 and ETACS-ECU connector D-223 in good condition?
YES: Replace the ETACS-ECU. The input signal from the back door lock actuator switch should be able to be checked and the functions, which are
described in the "Technical Description (comment)," should work normally.
NO: Repair them. The input signal from the back door lock actuator switch should be able to be checked and the functions, which are described in the
"Technical Description (comment)," should work normally.
Inspection Procedure Q-12
The door lock switch (incorporated in power window main switch and power window sub switch) signal is not sent to the ETACS-ECU
