Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 13. Check the harness wires between power window sub switch connector H-16 and ETACS-ECU connector D-223.
NOTE: After checking intermediate connector D-15, check the wires. If intermediate connector D-15 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
Q: Are the harness wires between power window sub switch connector H-16 and ETACS-ECU connector D-223 in good condition?
YES: Replace the ETACS-ECU. The door lock switch input signal should be able to be checked and the central door locking system should work
normally.
NO: Repair them. The door lock switch input signal should be able to be checked and the central door locking system should work normally.
Inspection Procedure Q-13
The hood switch signal is not sent to the ETACS-ECU
