Montero XLS 4WD V6-3.5L SOHC (2001)
STEP 1. Check the hood switch.
Q: Is the hood switch in good condition?
YES: Go to Step 2.
NO: Replace it. The input signal from the hood switch should be able to be checked and the theft-alarm system should be armed normally.
STEP 2. Check the hood switch ground circuit at hood switch connector A-14.
1. Disconnect hood switch connector A-14 and measure at the harness side.
2. Measure the resistance between terminal 2 and ground.
Q: Is the resistance less than 2 ohm?
YES: Go to Step 5.
NO: Go to Step 3.
STEP 3. Check hood switch connector A-14 for damage.
Q: Is hood switch connector A-14 in good condition?
YES: Go to Step 4.
