Montero XLS 4WD V6-3.5L SOHC (2001)
3. Apply multi-purpose grease to the new retainer, and assemble it to the new dust cover.
4. Fill multi-purpose grease inside the dust cover as shown.
Amount to use: 12 +/-1 g (0.4 +/-0.04 oz)
5. Apply multi-purpose grease to the dust cover lip.
6. Tape the stud threads to avoid damage.
CAUTION
Ensure grease does not come into contact with the ball joint threads and tapers. Wipe off the grease it contaminated.
7. Install the ball joint to the dust cover.
8. Secure the dust cover with the clip ring.
9. Engage the upper arm ball joint with the knuckle.
NOTE
Replace the inner race and outer race assembly as a set.
Lower
The contents of this article reflect the changes called out by TSB 04-33-001
