Montero XLS 4WD V6-3.5L SOHC (2001)
Drive/Propeller Shaft: Removal and Replacement
REMOVAL AND INSTALLATION
WARNING: Since the rear propeller shaft is made of CFRP, it is important to observe the following warning items strictly.
^
If a tear, chip or distortion is found on the tube, replace it with new one.
^
Do not drop, shock, or scratch the tube.
^
If the propeller shaft is scratched on the surface, inspect whether it is damaged or not using a dye penetrant.
^
If the propeller shaft is dropped on the ground, replace it with new one. If the dropped rear propeller shaft is reinstalled, the rear
propeller shaft may be broken.
^
When working with the propeller shaft, wrap the propeller shaft tube with the rubber sheet of 10 mm (0.39 inch) thick and over or with
the propeller shaft protector (part number MR581042) so that it is not scratched
^
If a crack or a tear is found on the seal portion at the end of CFRP tube shown in the illustration, replace the tube with new one.
^
Dispose of the damaged CFRP propeller shaft in compliance with Federal, state, and local laws. For disposing of CFRP products, we do
not recommend incineration.
