Montero XLS 4WD V6-3.5L SOHC (2001)
REMOVAL SERVICE POINTS
<<A>> FRONT PROPELLER SHAFT ASSEMBLY REMOVAL
1. Move the transfer shift lever to "2H".
2. Drain transfer gear oil.
3. Make mating marks on the differential companion flange and the flange yoke.
CAUTION: Be careful not to bend the joint portion when removing the propeller shaft because this will damage to the joint boot.
4. Remove the front propeller shaft assembly after placing a rag around the joint boot portion.
5. Cover the transfer case opening to prevent foreign material from entering.
<<B>> REAR PROPELLER SHAFT ASSEMBLY REMOVAL
When working with the CFRP propeller shaft assembly, wrap the shaft with rubber sheet to prevent damage.
1. Check that the rear propeller shaft assembly is wrapped with the rubber sheet.
2. Make mating marks on the differential companion flange and the outer race of ball joint assembly.
CAUTION:
^
Do not bend the joint portion when removing the propeller shaft because this will damage the joint boot.
^
Do not drop the air breather at the end portion of propeller shaft differential side into the propeller shaft ball joint.
^
Do not drop, shock, or scratch the propeller shaft.
^
If the propeller shaft Is dropped on the ground, replace it with new one. If the dropped rear propeller shaft is reinstalled, the rear propeller
shaft may be broken.
