Outlander 4WD L4-2.4L (4B12) (2008)
/Page-1233002.png)
REMOVAL AND INSTALLATION
CAUTION:
^
The parts indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb
weight condition.
^
The parts indicated by *2 are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and
soiling from the bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal & Post-installation Operation
Removal Steps 1-5
