Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
On the 420A (2.0L) engine, the tightening method is slightly different:
1.
Check the bolts for damage by laying a straight edge against the threads. If the threads are not even and level against the straight edge, replace the
bolt. Refer to the illustration.
2.
Tighten bolts # 1 through # 10 (in sequence) to 75 Nm (55 ft. lbs.). Refer to the sequence chart.
3.
Tighten bolts A through K (in sequence) to 28 Nm (20 ft.lbs.). Refer to the sequence chart.
Main Bearing Bolt Tightening Torque for Non-Elastic Bolts
Tightening Sequences for Non-Elastic Main Bearing Bolts (Engines not shown in the chart DO NOT have a specific main bearing bolt tightening
sequence.)
Elastic Main Bearing Bolts (Plastic/Angle Tightening Method)
The following vehicles/engines use elastic main bearing bolts:
