mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Valve Lash Adjuster Noise - Troubleshooting Procedures|Page 203 > < Tires - Goodyear(R) Product Service Locations
Page 1
background image

Lifter / Lash Adjuster: Technical Service Bulletins
Valve Lash Adjuster Noise - Troubleshooting Procedures

NO.: TSB-97-11-002
DATE: February, 1997
MODEL: See Below

SUBJECT:
NEW VALVE LASH ADJUSTER NOISE CHECKING AND TROUBLESHOOTING PROCEDURES

PURPOSE
This bulletin contains new information for checking and troubleshooting suspected valve lash adjuster noise for all listed affected vehicles. This
information is in addition to the information already in Group 11 of each vehicle's service manuals. Be sure to use the information in this bulletin along
with the service manual when diagnosing suspected valve lash adjuster noise.

AFFECTED MODELS
1991-97 3000GT
1992-96 Diamante
1990-97 Eclipse
1992-96 Expo/Expo LRV
1989-97 Galant
1990-92 Mirage
1989-97 Montero
1989

Starion

1990-96 Truck
1989-90 Van/Wagon

SERVICE MANUAL REVISION

The engine troubleshooting chart in the service manuals for all affected models requires one revision concerning the symptom of "Noisy valves". Make
the  change to all affected manuals as shown.

PROCEDURES

Lash Adjuster Noise Check

If an abnormal noise (chattering or clicking noise), suspected to be a malfunctioning lash adjuster, is produced immediately after starting the engine and
does not go away, perform the following checks:

NOTE:
(1)

An abnormal noise caused by a malfunctioning valve lash adjuster is produced immediately after starting the engine and changes with the
engine speed, no matter what the engine load.

Therefore, if abnormal noise is not apparent just after starting the engine, if it does not change with engine speed, or if it changes with
engine load, the noise is not caused by a malfunctioning lash adjuster.

Valve Lash Adjuster Noise - Troubleshooting Procedures|Page 203 > < Tires - Goodyear(R) Product Service Locations