Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
For Outlander and 2002-on Montero models, use 12-pin to 13-pin adapter harness MB991855 to connect the main harness to the data link
connector.
4.
Turn the ignition switch to the ON position.
MAIN MENU
Turn the ignition key to ON. When the VCI unit is turned on, the main menu displays:
IMPORTANT
^
When connecting and disconnecting, do not pull on the harness wires. Pull only on the connectors.
^
During reprogramming, the ignition switch must remain ON.
^
Do not disturb the MUT-III main harness during reprogramming. After reprogramming, start the engine to verify operation.
Automatic reprogramming is recommended for most typical reprogramming situations. If automatic reprogramming is not successful, try manual
reprogramming.
AUTOMATIC REPROGRAMMING
1.
In the VCI main menu. select "Automatic RPG". Then press ENTER.
The available data will display.
2.
Press ENTER. If the PCM requires reprogramming, the MUT-Ill will automatically identify the appropriate database. Press ENTER again to
transfer the reprogramming data to the VCI.
a.
If the PCM does NOT require reprogramming, this message displays. Press ENTER to return to the main menu.
b.
If there is no data for reprogramming this PCM, this message displays and no data is transferred. Press ENTER to return to the main menu.
