Raider 2WD V6-3.7L (2008)
14. Install the upper door striker trim covers (3) as follows:
-
Position the trim cover (3) to the headliner (2)opening around the door striker and engage the retaining tabs that secure the cover to the roof
rail.
15. Install the front seat headrests.
16. Seat the top of each of door seal to the door opening.
Extended Cab, With Rear Jumper Seats
NOTE: Headliner for Double Cab model shown. Extended Cab similar.
CAUTION: Be careful not to crease the headliner.
1. Position the headliner (6) in the vehicle through the door opening from which it was removed.
2. Connect the headliner wire harness connector (1) to the center high mounted stop lamp.
3. Raise the rear of the headliner (7) to the roof panel and install the two coat hooks.
4. Raise the front of the headliner to the roof panel and install the sun visor supports (3).
5. Connect the wire harness connector (5) located at the right A-pillar.
