Altima GXE L4-2.4L (KA24DE) (1999)
3. Press support bearing assembly off drive shaft.
4. Separate support bearing from retainer.
INSPECTION
Thoroughly clean all parts in cleaning solvent, then dry with compressed air. Check parts for evidence of deformation or other damage.
Drive Shaft
Replace drive shaft if it is twisted or cracked.
Boot
Check boot for fatigue, cracks, or wear. Replace boot with new boot bands.
Joint Assembly (Transaxle Side)
Replace joint assembly if it is deformed, damaged or operates abnormally.
Joint Assembly (Wheel Side)
Replace joint assembly if it is deformed, damaged or operates abnormally.
Support Bearing
Make sure wheel bearing rolls freely and is free from noise, cracks, pitting or wear.
Support Bearing Bracket
Check support bearing bracket for cracks with a magnetic exploration or dyeing test.
ASSEMBLY
CAUTION:
-
After drive shaft has been assembled, ensure that it moves smoothly over its entire range without binding.
-
Use NISSAN GENUINE GREASE or equivalent after every, overhaul.
Wheel Side