Cube L4-1.8L (MR18DE) (2010)
Transmission Speed Sensor: Service and Repair
Secondary Speed Sensor
Exploded View
SECONDARY SPEED SENSOR
Exploded View
Removal And Installation
SECONDARY SPEED SENSOR
Removal and Installation
REMOVAL
1. Remove air duct (inlet). See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair/Exploded View.
2. Disconnect secondary speed sensor connector.
3. Remove secondary speed sensor.
4. Remove O-ring from secondary speed sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
-
Never reuse O-ring.
-
Apply CVT fluid to O-ring.
Inspection
SECONDARY SPEED SENSOR
Inspection
INSPECTION AFTER INSTALLATION
Check for CVT fluid leakage and check CVT fluid level. See: Fluid - CVT/Service and Repair/Inspection.