Murano AWD V6-3.5L (VQ35) (2003)
12. Loosen bolts in reverse order of illustration with power tool, and remove intake manifold collector (upper and lower) assembly with power tool.
Intake Manifold Upper Collector / Torque Sequence
13. Loosen bolts in reverse order of illustration to remove intake manifold collector (upper) with power tool.
14. Remove power valve in reverse order of illustration.
INSPECTION AFTER REMOVAL
Surface Distortion
^
Using straightedge and feeler gauge, inspect the surface distortion of intake manifold collector (lower).
Limit : 0.1 mm (0.004 inch)
^
If it exceeds the limit, replace the intake manifold collector.
INSTALLATION
^
Install in the reverse order of removal paying attention to the following.
Installation of Power Valve
^
Tighten in numerical order as shown in the figure.
17.6 - 21.6 Nm (1.8 - 2.2 kgf-cm, 13 -15 ft. lbs.)