Murano FWD V6-3.5L (VQ35) (2004)
3. Remove center pillar lower garnish.
4. Remove center pillar upper garnish.
INSTALLATION
Install in the reverse order of removal.
DASH SIDE FINISHER
REMOVAL
1. Remove front kicking plate.
2. Remove front body side welt.
3. Remove dash side finisher.
NOTE: Insert screw driver rolled with cloth between panel on vehicle and disconnect clips.
INSTALLATION
Install in the reverse order of removal.
NOTE: To install, check if all clips are matched over holes of panel on vehicle, then push on.
FRONT PILLAR GARNISH
REMOVAL
Remove front pillar garnish clips and remove front pillar garnish.
INSTALLATION
Install in the reverse order of removal.
FRONT AND REAR KICKING PLATE
REMOVAL
Remove kicking plate clips and remove kicking plate.
INSTALLATION
Install in the reverse order of removal.
FRONT AND REAR BODY SIDE WELT
REMOVAL
Remove body side welt.
INSTALLATION
Install in the reverse order of removal.