Murano FWD V6-3.5L (VQ35DE) (2006)
Drive Belt: Service and Repair
Removal and Installation
REMOVAL
1. Remove splash guard (RH).
2. Fully loosen each belt by following the guidelines in EM-13, "Tension Adjustment". Remove alternator and A/C compressor belt and then power
steering oil pump belt.
CAUTION: Grease is applied to idler pulley adjusting bolt. Be careful to keep grease away from belt.
INSTALLATION
1. Install each belt to pulley in the reverse order of removal.
CAUTION:
^
Make sure belt is correctly engaged with the pulley groove.
^
Make sure that for engine oil, working fluid and engine coolant do not adhere to belt and each pulley groove.
2. Adjust belt tension.
3. Tighten each nuts and bolts to the specified torque.
4. Make sure that tension of each belt is within the standard.