Pathfinder LE 4WD V6-3.3L (VG33E) (1997)
^
Refer to Figure 2 that applies to your model.
^
There should be continuity across the terminals with the throttle closed.
NOTES:
^
An ohmmeter is used because CONSULT-II cannot display the CTPS status in all of the Applied Vehicles.
^
This adjustment procedure must be made with the TPS installed on the engine of the vehicle.
^
Do not touch the throttle drum when checking the CTPS signal or continuity. Doing so may cause an incorrect adjustment.
^
Nissan recommends using Kent-Moore TPS Connector Tool J-45178 for easy, accurate connection. See NTB01-023 for more information.
4.
Refer to Chart 1 and select the correct thickness feeler gauges for your vehicle.
5.
Check "A":
Insert the thinner feeler gauge "A" (from Chart 1) between the throttle adjustment screw and the throttle drum stop.
^
The CTPS should have continuity. (ohmmeter reads "0 ohms").