Quest Minivan GLE V6-3.3L (VG33E) (1999)
-
After drive shaft has been assembled, ensure that it moves smoothly over its entire range without binding.
-
Use NISSAN GENUINE GREASE or equivalent after every overhaul.
Support Bearing
1. Install bearing into retainer.
2. Install snap ring.
3. Install dust shield.
4. Press drive shaft into bearing.
5. Install snap ring.
6. Install new dust shield.
Wheel Side
1. Install boot and new small boot band on drive shaft.
-
Cover drive shaft serration with tape so as not to damage boot during installation.