Rogue 2WD L4-2.5L (QR25DE) (2008)
Seat Back: Service and Repair
Front Seat
DISASSEMBLY AND ASSEMBLY
SEATBACK (EXCEPT FOLDING SEAT)
Disassembly
1. Remove the utility hook.
Remove the screw. (Passenger's seat only)
2. Remove the seatback trim and seatback pad.
-
Remove the seatback retainer (1) on the back side of the seatback.
-
Unfasten fastener (2) on the back side of the seatback.
-
Remove the hog rings.
-
Remove the screw cap
-
Remove the screws, and then remove seatback finisher.
-
Remove the side air bag module.
-
Remove the side air bag harness connector (A) and clamp.
-
Disconnect the seatback heater unit harness connectors (B).
-
Remove the headrest holder.
CAUTION: Before installing headrest holder, check its orientation. (front/rear and right/left)
-
Remove the seatback trim and seatback pad from the seat frame assembly.
-
Remove the hog rings to separate the seatback trim and seatback pad.
3. Remove the seatback silencer.