Rogue 2WD L4-2.5L (QR25DE) (2008)
NOTE: Use a hard metal pin with the diameter of approximately 1.2 mm (0.047 in) as a stopper pin.
c. Remove balancer unit timing chain tensioner.
^
When the holes on lever and tensioner body cannot be aligned, align these holes by slightly moving the slack guide.
15. Remove balancer unit timing chain and crankshaft sprocket.
16. Loosen mounting bolts in reverse order as shown in the figure, and remove balancer unit.
<---: Engine front
CAUTION: Never disassemble balancer unit.
NOTE: Use TORX socket (size E14).
INSTALLATION
NOTE: The figure shows the relationship between the mating mark on each timing chain and that on the corresponding sprocket, with the components
installed.
1. Check that crankshaft key points straight up.