Alero L4-144 2.4L DOHC VIN T SFI (2000)
Fuel Line Coupler: Service and Repair
Plastic Collar
REMOVAL PROCEDURE
1. Grasp both sides of the quick-connect fitting. Twist the female connector 1/4 turn in each direction in order to loosen any dirt within the
quick-connect fitting.
CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.
2. Use compressed air in order to blow any dirt out of the quick-connect fitting.
3. Squeeze the plastic retainer release tabs.
4. Pull the connection apart.
INSTALLATION PROCEDURE
CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean
engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-ring located in the female connector will swell and may prevent proper reconnection if not lubricated.
1. Apply a few drops of clean engine oil to the male fuel pipe end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs to snap into place.
3. Pull on both sides of the quick-connect fitting in order to ensure the connection is secure.
