Alero L4-144 2.4L DOHC VIN T SFI (2000)
Seals and Gaskets: Service and Repair
Removal Procedure
^
Tools Required
-
J 38868 Shaft Removal Tool
-
J 6125-1B Slide Hammer
-
J 23129 Seal Removal Tool
Caution: Refer to Vehicle Lifting Caution in Service Precautions.
Important: Do not damage the seal bore or the sleeve assembly. Fluid leaks may result.
1. Raise and support the vehicle.
2. Remove the drive axle assembly. Refer to Wheel Drive Shafts Replacement.
3. Remove the snap ring from the stub axle shaft. Discard the snap ring. Do not reuse.
4. Remove the stub shaft from the transmission. Use the J 6125-1B and the J 38868.
5. Pull lightly on the shaft. Rotate the shaft until the output shaft snap ring at the differential seats in the taper on the differential side gear.
6. Remove inner snap ring.
7. Remove the right hand axle seal from the transmission. Use the J 23129 and the J 6125-1B or a screwdriver.
Installation Procedure
^
Tools Required
-
J 41102 Axle Seal Installation Tool
