Cutlass V6-191 3.1L VIN M SFI (1998)
16. If damage to the guide pin bolts or the bores are found, replace with new parts when installing the caliper.
17. Do not attempt to polish away corrosion.
INSTALLATION PROCEDURE
1. Liberally coat the inside diameter of the bores (1) using silicone grease.
2. Install the mounting guide pin bolts (10) and sleeve assemblies.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the caliper (3) over the rotor onto the caliper bracket.
-
Tighten the mounting bolt and sleeve assemblies to 31 Nm (23 ft. lbs.).
4. Install the inlet fitting (1), if removed.
-
Tighten the inlet fitting to 50 Nm (37 ft. lbs.).
5. Remove the wheel nuts securing the rotor to the hub and bearing assembly.
6. Install the wheel and tire. Align the previous marks that were made during removal.
7. Lower the vehicle.
8. Tighten the wheel nuts.
9. Fill the master cylinder to the proper level with clean brake fluid.
10. Recheck the fluid level.
11. Recheck the brake pedal feel. If brake sponginess is present, refer to "Brake System Diagnosis (Hard pedal)".
