Cutlass V6-191 3.1L VIN M SFI (1998)
Engine Torque Strut: Service and Repair
Engine Mount Strut Replacement
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting.
3. Remove the right splash shield. Refer to Splash Shield Replacement in Bumpers.
4. Remove the engine mount strut bolts.
5. Remove the engine mount strut.
INSTALLATION PROCEDURE
1. Install the engine mount strut.
2. Install the engine mount strut bolts.
^
Tighten the bolts to 115 Nm (85 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the right splash shield. Refer to Splash Shield Replacement in Bumpers.
4. Lower the vehicle.
5. Connect the negative battery cable.
